parts for scotts standard broadcast spreader

Using a tape measure, accurately measure off a specific area on a hard, easy-to-sweep surface, such as a driveway. In a nutshell, here's how to calibrate a spreader.įor most BioAdvanced products, the goal is to apply a specific number of pounds of product per 1,000 square feet. You do not want over apply product or this could possibly damage your lawn. This is especially important when applying herbicides or fertilizers. Each BioAdvanced product or products from other manufacturers will require different settings. It’s important to know that the goal is to calibrate your spreader for each BioAdvanced product. Once you are comfortable that you have the correct setting – write it down in a convenient place for future reference. weight per 1,000 square feet × ÷ 1,000 square feet = weight that needs to be appliedĪdjust the setting as necessary to spread the product evenly over the entire area.Using this information, apply the following calculation to determine how many pounds per square feet pertains to your property. What you are left with is the amount that was distributed over the 50 to 100 feet area. When you are finished, reweigh the amount of remaining granules and subtract this from the original amount. While walking at a brisk pace, distribute the granules over the testing area. Distribute the product over the measured area. Measure out about 1/3 of the product’s total weight in pounds into your spreader. Some common measurements for approximately 1,000 square feet are: Mark these areas with chalk, a string line or other method to close off the test site. Use a tape measure to be as accurate as possible. We recommend that you start your project by measuring a 50 to 100 feet strip to test different calibrations. 100 lbs per acre = 2.5 lbs per 1,000 square feet.1 lb per 1,000 sq ft = 43.6 lbs per acre.If you want to use a manual process to find out the best estimate for your spreader setting, a good starting point is to consider the following: Other BioAdvanced products, or products from other manufacturers, will require a different setting. REMEMBER: The goal is to calibrate your spreader for a specific BioAdvanced product. Your local Cooperative Extension System office may also have information on how to calibrate your spreader. You can always contact BioAdvanced at 1-87 or use our live chat feature at for assistance. They probably won't have specific settings for BioAdvanced products, but they should have information on how to calibrate your spreader so it applies the right amount of product over a specific area. If the setting for your spreader is not on our package, the first thing you could do is visit the spreader manufacturer's website and see what kind of help they offer. The truth is there are just too many spreader models and manufacturers to test and list them all. Your spreader is NOT listed on the package?

Parts for scotts standard broadcast spreader